Sheet Metal Coil Slitter shaft inside each roller and the corresponding components are required to unfold the refueling, the same is a three times a week. When the air humidity in the production workshop is below 50%, due to the static electricity effect, the warp-supporting car flies to start and presses off a lot, and in a more serious case, a running against the warping worker finishes a factory silk shaft head, and has to be chemicalized for more than 2 bells.
We run against the silk fabric slitter machine steel warping machine on the modified oiling equipment to deal with the static electricity caused by the beginning of the fly problem, on the same a shaft head only forty-five minutes, not only to ease the labor efficiency of the staff, but also enhance the high efficiency.
Slitter Steel Routine Maintenance:
1. Wipe (pressure wheel, roll out shaft and trauma can not have dirt).
2. When there is no need, pay attention to power off.
3. Screws and traumas should be often refueled to prevent rust treatment.
Frequently Asked Questions:
1. When removing and replacing specifications, be sure to back off the upper cutter working pressure before turning over the upper cutter seat, otherwise it will destroy the cutter head. Long-term without the need to be on the rust treatment oil or oil.
2. Cutting raw materials are limited to paper products, many very long class, PC, PVC, ABS class, thin and thick within 250#. Can not be used to cut metal materials and other hard raw materials.
The steel strip slitting machine has to be greased in the area of the left and right knives, three times a week. The clutch area of the feed knife should be lubricated. The threadless extruder screw has to be greased on its drive system shaft, which then moves up and down, three times a week. The sealing rolls in the cylinder of the rechargeable battery slitter need to be neatly organized, and the area of the fish eyeballs should be lubricated.
The rolling bearings and the loading frame are oiled once every three days. In the case of oiling the area of the discharge shaft pin, we need to use a grease gun to inject oil, and before oiling, we need to organize the area of oiling first. If the brake pedal connection area to start refueling, after filling the oil to move him back and forth, every week to start three times the moisturizing, but also need to pay attention to the finishing.
The above is about the slitting machine related knowledge to explain, if you have any other questions you want to know, are welcome to contact us.
