1. Acceptance of the slitting line machine, because it involves the assembly of the tool, and therefore often need the user and the equipment manufacturer to jointly carry out the acceptance. Before acceptance, in order to ensure smooth acceptance, need to do some preparatory work in advance. First of all, the user and the equipment manufacturer together to complete the static accuracy test of the metal slitting machine.
2. This test is carried out by measuring the shoulder difference between the two cutter shafts using a ruler or a square bar. Typically, the square rod has a cross-section of about 40 mm or 50 mm square and a length of about 40 to 50 mm more than the diameter of the slitter blade. After the measurement has been made, two sets of thin rings should be selected in conjunction with this result so that their difference is equal to this deviation, and then mounted on the cutter shafts.
3. This will offset this deviation. If a suitable one cannot be found, then it will need to be recreated. At this point should be elected to complete the gap cut. Because the cutting of the gap is the basis for subsequent cutting, and therefore need to go through a number of feelers to analyze whether the two sets of thin ring difference is accurate. After a number of tests, only to prove that the selected gap is correct, then the two sets of thin rings can be fixed, used as a shoulder deviation trimming to match the steel coil slitting machine operation.
4. The staff can only according to the requirements of the slitting machine equipment for the overall debugging and test run. It should be noted that, in the debugging process of knives and tools used, shall be strictly in accordance with the specifications of the knife software requirements and the number of orderly take out.
