When the steel coil slitting line is used, no matter for the work of unwinding or rewinding, the diameter of the roll in the slitting machine equipment for operation, it is inevitable that with a wide range of changes in time, to cause a wide range of changes in a parameter within the control system corresponding to it. This slitter equipment in use, for the direct impact of the system's dynamic and static quality, are considered a result.
When it comes to the tension control of the sheet slitting machine, it simply refers to the tension taper control. Slitter tension control role is in fact to prevent the use of equipment, coil internal stress phenomenon, on the basis of this prevention, but also by the core of the strip due to extrusion, and deformation of bad wrinkles, which produces scrap, will inevitably result in our neighboring discs between the edge of the strip appeared to be interlocking, but also lead to the phenomenon of can not be divided into disks.
Slitter equipment on the system is good or bad, the actual use of the time, the main thing is to look at our system is not able to meet the requirements of one of its processes. Note that to use a comparative design ideas to control, the system itself, the control system in use, but also to ensure that the equipment itself has a better mechanical and electrical performance.
Metal slitting line in the steady state, the equipment of the time line speed is in a constant outside, for its system, then it is bound to be required to be in a constant tension unwinding state, but also can change the tension winding state. In the winding time, the slitting machine equipment winding tension should also pay attention to with our winding radius to increase to its corresponding adjustment.
