The key to aluminum coil slitting machine repair is to keep the assembled aluminum plate on its surface. Aluminum plate longitudinal shear straightening equipment is mainly for all kinds of aluminum plate straightening and aluminum plate shearing with good application effect. It adopts a variety of processing principles to cut different kinds of plates and plates with different properties.
When the aluminum coil longitudinal slitting straightening machine equipment maintenance, pay attention to the surface of the steel plate coated with lubricating oil or grease, and regularly coated. The general period is one month; in the process of refueling, it should be noted that the equipment should be in a power-off and stationary state so as not to pose a threat to life; in addition, for the maintenance of the steel plate, attention should be paid to the maintenance of its bearings and devices. Generally speaking, after daily operation, check whether the parts are loose and whether the equipment is hygienic. No debris should be allowed to fall into the equipment, and regular hygiene inspections and maintenance should be done.
The main slitter maintenance matters can be divided into the following points:
1. Regular inspection and maintenance
Lubrication: Make sure all moving parts are properly lubricated to minimize friction and wear.
Cleaning: Clean the equipment regularly to prevent dust and impurities from entering the mechanical parts and affecting normal operation.
Tightening: Check and tighten all bolts and connectors to prevent loosening and causing equipment failure.
2. Checking the electrical system
Cables and wiring: Check the cables and wiring regularly to ensure that there is no aging, wear and tear, or looseness.
Electric control box: clean the inside of the electric control box and check the working condition of each contactor, relay and switch to ensure the safety and reliability of the electrical system.
3. Maintenance of mechanical parts
Blade: check and replace the blade regularly to keep the blade sharp and ensure the cutting quality.
Guiding device: check the straightness and wear of the guiding device, adjust or replace if necessary.
Transmission system: check the wear and tear of the belt, chain and gear of the transmission system, and carry out maintenance and replacement in time.
4. Maintenance of the hydraulic system
Hydraulic oil: Replace the hydraulic oil regularly to keep the hydraulic system clean and prevent system failure caused by hydraulic oil contamination.
Hydraulic pumps and valves: check the working condition of hydraulic pumps and valves to ensure their normal operation.
5. Operator training
Training: Conduct regular training for operators to familiarize them with the operating procedures and maintenance requirements of the equipment.
Records: Operators should make records of equipment operation and maintenance, and report abnormalities of the equipment in time.
6. Spare parts management
Spare parts reserve: according to the use of equipment, reasonable reserve of commonly used spare parts, to ensure that maintenance can be replaced in a timely manner.
Quality Assurance: Choose reliable quality spare parts to avoid equipment failure caused by the use of poor quality parts.
