Cut To Length Line is used to decoiler, straightener, size and cut the metal coil into flat sheets of required length and stack them. It is suitable for processing cold rolled and hot rolled carbon steel, silicon steel, tinplate, stainless steel and all kinds of metal materials after surface coating. It has high degree of automation, simple and reliable operation. High precision of fixing length, high flatness of sheet material. Stacking neatly and other product characteristics.
How to standardize the operation Cut To Length Line?
1. First of all, turn on the power, turn on the key switch on the control panel, and then press the oil pump to start.
Then press the oil pump start, so you can hear the sound of the oil pump rotating. (At this time the machine does not move).
2. Shear plate material must pay attention to is the gap adjustment, generally located on the side of the machine.
According to the 12% to 15% of the sheet to adjust the gap, the gap value can be read in the dial. (Such as shear 10mm sheet, you can adjust the gap for 0.12mm).
3. After the blocking material adjustment generally have electric quick adjustment and manual fine-tuning, you can first use the electric adjustment is the approximate size in the manual fine-tuning to the position you need to cut. 4.
4. Depress the foot switch until the sheet shear section in the release, otherwise the midway release will automatically lift.
In order to maintain the accuracy of the horizontal shear, to extend its service life, as well as to protect personal and equipment safety, the operation must strictly comply with the following safety regulations:
1. Wear work clothes neatly, female workers should wear a good working cap.
2. Before driving, you must check whether the machine handle and running part is normal.
3. The material should be stuck correctly, clamped, and check whether the leveling and straightening equipment is opened synchronously.
4. After loading the material, we should determine the center positioning and check whether the hole distance is correct.
5. Must stop and change speed. When the machine is running, it is strictly prohibited to touch the material with your hands, and you can not touch the mold and motor with your hands.
6. The machine tool guideway, molds are strictly prohibited to put work, measuring tools and gloves and other items.
7. Do not leave the machine tool after powering on, to concentrate on the operation.
8. At the end of the day, clean the machine, organize the site, cut off the power supply to the machine. Lubricate the gears of the machine.
9. During processing, if you find the machine running sound abnormal or failure, you should immediately cut off the power supply, diagnose the problem or notify the manufacturer.
