As a large coil processing line, metal slitting machine may face the possibility of wear and tear of the equipment components during the production process, which will ultimately lead to the productivity, precision and equipment life will be affected. Professional operation and maintenance can effectively ensure that all parts of the equipment are functioning properly and avoid production line downtime due to wear and tear, aging or malfunction. This helps to increase productivity and reduce downtime, thereby improving the consistency and quality of the metal products produced.
Preventive maintenance allows potential problems to be identified in advance and resolved in a timely manner, avoiding costly repairs and production downtime in the event of a major equipment failure. Below are recommendations related to slitter equipment maintenance:
1. In the process of using the metal slitting machine, proper lubrication care is very important. Due to the use of different situations, so its different parts of the lubrication requirements are not the same. For example, for the discharge seat, sliding bearings, usually every three days for a lubrication care, after adding grease, but also need to move around to ensure that the lubrication is adequate!
2. For the steel slitting machine equipment discharge shaft pressure plate parts of the sliding bearing, in the lubrication care, usually once a week using a grease gun refueling. Remember, before refueling, you also need to clean the refueling place, so as not to contaminate the oil.
3. For the equipment of the brake system should also pay attention to good lubrication care. For the brake connection parts in the addition of lubricant also need to move back and forth many times to ensure adequate lubrication. Usually the part should be lubricated three times a week, and pay attention to clean.
4. For the slitting machine equipment, such as rollers and adjustment parts, according to the actual situation should be adjusted accordingly, in the filling of lubricant, pay attention to keep clean, usually three times a week lubrication. In addition for the upper and lower knife adjustment, such as worm gear worm also need three times a week for lubrication and maintenance, pay attention to clean.
5. For the metal slitting machine under the knife shaft clutch parts also need three times a week lubrication protection, and keep clean. Also pay attention to three times a week for the waste winding support shaft grease, and left and right to move the organization many times.
