Acceptance and commissioning of the metal slitter equipment is also an important work that should not be taken lightly, and it is of great significance to both users and manufacturers. Therefore, in the conduct of this work, KINGREAL STEEL SLITTER recommend that the user and the manufacturer to cooperate with each other, and jointly participate in the commissioning of the slitting machine equipment. In addition, in the acceptance of the time, the user friend should prepare what?
First of all, as a user, we should take the initiative to cooperate with the manufacturer of the steel slitting equipment, and together to complete the static accuracy test of the slitter equipment. Specific content includes: the use of straightedge, it is recommended that the better choice of square rod to measure the two knife shaft shoulder difference. Note that the cross-section of the square bar should be kept at 40mm or 50mm square, and its length should be slightly larger than the diameter of the blade by 40 ~ 50mm.
Once the situation explained above is understood, the staff will need to select two sets of thin rings from the thin ring material provided at the supplier and make their difference match this deviation, after which they will be mounted on the cutter shaft so that this deviation can be eliminated. If they don't fit, they need to be made again. After completing this work, we also need to finish cutting the gap of the steel coil slitting machine.
It should be reminded that, in the gap cutting work, we must ensure the best possible results, because it will have a very important impact on the later cutting. Therefore, after the work is also completed, we can only according to the requirements of the coil slitting machine equipment for full commissioning and trial production. In the debugging time, special attention should be paid to the debugging of the tool used.
During commissioning, the staff needs to carry out cleaning work to maintain better cleanliness, especially on both sides of the blade. Otherwise, if there are impurities, it will affect the cutting accuracy of the metal slitter machine equipment, affecting the quality of products.
KINGREAL STEEL SLITTER as a professional steel slitting machine manufacturer, KINGREAL STEEL SLITTER insists on bringing high quality COIL SLITTING MACHINE to our customers and assisting them to do a good job in inspecting the metal slitting machine.
